Cross Section Point Properties

Edit the Points on a cross section

Point
This is the point in the job which is used to store the CS values

Offset
Enter the point offset from the longsection point. When you change this value the point will be moved in Easting/Northing along the cross section to the required offset.

Natural RL
Enter the natural surface height value. This is the same as the point Z(Height) value.

Design RL
This is the design surface height (RL). This cannot be edited, it will be computed when the cross section design is computed using the templates.

Boxing RL
This is the design boxing level height. This cannot be edited, it will be computed when the cross section design is computed using the templates.

Code
This is the point code.

Press this button to move to the previous point on the cross section

Press this button to move to the next point on the cross section

General information and Frequently Asked Question.